C10-310-901-VT - 310901 - CIP1 EXCLUSIVE - CHROME BEZEL CYLINDER HEAD 600F TEMP GAUGE KIT - 52MM 2-1/16 INCH - WITH 6.6MT (21.5 FOOT) WIRING HARNESS FOR 14MM SPARK PLUG - BEETLE/KARMANN GHIA/BUS/TYPE-3 - REF.# EMPI 14-1139-0

Description

Another Cip1 Exclusive!

We have brought back the Classic VDO Cockpit style Cylinder Head Temperature Gauge kit. The 4.5 Meter kit is suitable for all Beetle, Karmann Ghia, Type-3 applications along with all Aircooled early Porsche Models such as 356 / 911 / 912 and 914. We also offer a version with a 6.6 Meter cable for Van / Bus and Vanagon applications using 14mm spark plugs.

Cylinder Head Temperature Gauge Installation

Gauge part number: C10-310-901-T2

Operational voltage: 10 - 16volts

For fitment to Negative Earth vehicles only.

Caution: Disconnect The Negative Battery Cable Prior To Any Installation

The cylinder head temperature gauge is supplied complete with an electrical connection harness. The harness contains three leads, thermocouple lead terminating in a 14mm diameter eyelet. The lead length is:

Either 4.5meters for Beetle application
Or 6.6meters for Van application.

The other end of the harness is a multi-plug connector which fits to the rear of the gauge.

Gauge requires a 52mm aperture for fitment

Open tailgate and identify cylinder number 3. As you stand looking at the engine, it is left hand side nearest the bulkhead
Remove spark plug complete with crush washer from cylinder number 3. Ensure the crush washer remains around the plug.
Place 14mm eyelet over spark plug thread
Refit spark plug. Make sure the 14mm eyelet is closest to the cylinder block.
Connect the remaining leads as follows:
1. Black to ground
2. Green to ignition switched +12volts
3. Red/white lead is for the internal LED illumination, connect to +12volts side light feed.
Fit multi-plug connector to gauge and reconnect negative battery cable.
Switch on ignition. Gauge pointer will perform full scale sweep.

Manufactured under ISO9001:2015 quality standard